The air purge collar is used to keep dust, moisture, airborne particles, and vapors away from the lens. It can be mounted before or after the bracket. A 4mm (.16 in) outside diameter plastic tubing is recommended to connect the fitting. The pressure of air should be between 0.6 and 1 bar (8.7 to 15 PSI). Clean, oil free air is recommended. (Metric Thread)

The right angle mirror is used to turn the field of view by 90 degrees against the sensor axis. It is recommended when space limitations or excessive radiation do not allow for direct alignment of the sensor to the target. The mirror must be installed after the bracket and the air purge collar and must be screwed in fully.

The right angle mirror is used to turn the field of view by 90 degrees against the sensor axis. It is recommended when space limitations or excessive radiation do not allow for direct alignment of the sensor to the target. The mirror must be installed after the bracket and the air purge collar and must be screwed in fully. (Metric Thread)

The protective window is made from silicon and can be directly screwed to the sensing head.

The protective window is made from silicon and can be directly screwed to the sensing head. (Metric Thread)

Air/Water Cooled Housing (for units with high temperature cable)

Mounting Nuts (2) for Raytek CI Infrared Sensors

Mounting Nuts (2) for Raytek CI Infrared Sensors (Metric Thread)

Fixed Mounting Bracket for Raytek CI, CM Infrared Sensors

Adjustable Mounting Bracket for Raytek CI, CM Infrared Sensors

The aluminum air purge collar is used to keep dust, moisture, airborne particles, and vapors away from the lens. It can be mounted before or after the bracket. A 4mm (.16 in) outside diameter plastic tubing is recommended to connect the fitting. The pressure of air should be between 0.6 and 1 bar (8.7 to 15 PSI). Clean, oil free air is recommended.

The stainless steel air purge collar is used to keep dust, moisture, airborne particles, and vapors away from the lens. It can be mounted before or after the bracket. A 4mm (.16 in) outside diameter plastic tubing is recommended to connect the fitting. The pressure of air should be between 0.6 and 1 bar (8.7 to 15 PSI). Clean, oil free air is recommended.