The products below are available right now, we just don't have a page created for them yet. Please contact us for inquiries in the meantime.
List View
Replacement mounting feet for Allied Moulded AMP and AMU series enclosures.
The Hammond 1554UPL back panel is used to mount/install electrical components to without having to install them directly onto the enclosure walls. Making the process of swapping out or updating the electronics in your enclosure quicker and easier.
The Hammond 1427BCG series liquid-tight cable glands are used to seal cable entries, keep contaminants from entering enclosures, provide strain relief and thus reduce stress on components and termination points inside enclosures.
The Hammond 14A0505 back panel is used to mount/install electrical components to without having to install them directly onto the enclosure walls. Making the process of swapping out or updating the electronics in your enclosure quicker and easier.
The Hammond 1554VAPL back panel is used to mount/install electrical components to without having to install them directly onto the enclosure walls. Making the process of swapping out or updating the electronics in your enclosure quicker and easier.
The Hammond 14R0705 back panel is used to mount/install electrical components to without having to install them directly onto the enclosure walls. Making the process of swapping out or updating the electronics in your enclosure quicker and easier.
The Hammond 14G0705 back panel is used to mount/install electrical components to without having to install them directly onto the enclosure walls. Making the process of swapping out or updating the electronics in your enclosure quicker and easier.
The Hammond 1550B is a rugged diecast aluminum enclosure finished in a natural vibra finish for a smooth surface with no sharp edges. Includes stainless steel philips head machine screws used to secure lid into factory tapped holes. The enclosure is designed to meet IP54 and does not include a gasket.
The Hammond 1550WB is a rugged diecast aluminum enclosure finished in a natural vibra finish for a smooth surface with no sharp edges. Includes stainless steel philips head machine screws used to secure lid into factory tapped holes. The enclosure is designed to meet IP66 when the included water tight gasket is installed.
The Saginaw Control & Engineering SCE-ELJMFK mounting foot kit, sold in set of 4 feet
The Saginaw Control & Engineering SCE-ELMFK4 mounting foot kit, sold in set of 4 feet