The products below are available right now, we just don't have a page created for them yet. Please contact us for inquiries in the meantime.
List View
The Hammond PJU664LF is designed for use as instrument enclosures, electric, hydraulic or pneumatic control housings, electrical junction boxes or terminal wiring enclosures.
The Hammond N1WS1088 is designed for indoor use to enclose controls, instruments, and components which do not require oil-tight or dust-tight protection.
The Hammond PCJ14126CCHF is designed to insulate and protect controls and components in both indoor and outdoor conditions.
The Hammond 1437MD is designed to accept standard heavy duty oil tight pushbuttons, switches and pilot lights.
The Hammond 1427NCG series liquid-tight cable glands are used to seal cable entries, keep contaminants from entering enclosures, provide strain relief and thus reduce stress on components and termination points inside enclosures.
The Hammond R101-120-000 is designed to provide a degree of protection from accidental contact with the enclosed equipment and external environmental conditions.
The Hammond PCJ14126NLF is designed to insulate and protect controls and components in both indoor and outdoor conditions.
Hammond GP1507S16 is a stainless steel gland plate, designed to fit 12 x 4.5" openings
The Hammond C3RWT648 is designed for use to protect multiple wiring junctions in outdoor environments against the ingress of rain, sleet, snow and the external formation of ice.
The Bud Industries PA-1105-BT back panel is used to mount/install electrical components to without having to install them directly onto the enclosure walls. Making the process of swapping out or updating the electronics in your enclosure quicker and easier.
The Bud Industries PA-1105-MG back panel is used to mount/install electrical components to without having to install them directly onto the enclosure walls. Making the process of swapping out or updating the electronics in your enclosure quicker and easier.
The Bud Industries PA-1105-WH back panel is used to mount/install electrical components to without having to install them directly onto the enclosure walls. Making the process of swapping out or updating the electronics in your enclosure quicker and easier.